Concrete Contractors in Tar Landing, NC | Residential & Commercial Concrete
Jacksonville Concrete Contractors provides concrete installation, repair, and replacement for homes and businesses throughout Tar Landing, NC, a populated place inside Jacksonville Township in Onslow County. We pour driveways, patios, walkways, slabs, and foundations using mix designs and reinforcement schedules matched to the sandy, low-elevation soil common across this part of the county. Because Tar Landing sits close to the New River and shares the coastal humidity and heavy rainfall found throughout Onslow County, our crews compact a gravel sub-base and grade every project for drainage before a single truck of concrete arrives.
We time pours around the region's long, hot, and humid summers and its brief, mild winters, since both extremes affect how concrete cures. Homeowners along roads like Tar Landing Road often need extended driveways or replacement slabs on properties with more land and looser soil than in denser parts of Jacksonville. We also handle stamped and decorative finishes suited to the salt air and UV exposure typical of this stretch of coastal North Carolina. Our team serves Tar Landing alongside Jacksonville, Hubert, Richlands, and Swansboro, NC. Every job starts with a site evaluation so the mix, base, and reinforcement match the ground conditions found at that specific address.

Get a FREE Quote
Jacksonville Concrete Contractors offers a full range of concrete services in Tar Landing, NC, covering everything from vehicle surfaces to structural foundations for local businesses and homeowners. We pour and repair driveways, patios, walkways, garage floors, and equipment pads, along with foundations and slabs for new construction and additions. Property owners near Tar Landing Road and the surrounding rural lots often need larger pours than tighter in-town lots require, so we scale our crews and equipment to the size of the property. We also install decorative and stamped finishes for homeowners who want a custom look without the upkeep of pavers or natural stone.

We design and pour concrete driveways built to handle daily vehicle traffic, coastal humidity, and the sandy soil common around Tar Landing, NC. Every slab gets steel or fiber mesh reinforcement sized to the vehicle load it needs to carry. We offer broom, exposed aggregate, and stamped finishes, and we regularly extend driveways to accommodate the larger lots found along Tar Landing Road. Our crews also pour RV pads and extended parking areas for properties set back from the main road.
Our patio and porch work extends usable outdoor space while holding up to the seasonal humidity swings typical of this part of Onslow County. We pour stamped, stained, and broom-finished surfaces and grade every patio to move water away from the home. Many Tar Landing homeowners pair a new patio with a fire pit area, outdoor kitchen, or pool deck, and we match new pours to existing surfaces on partial replacements. Drainage slope gets extra attention here given how much rain this region receives during summer storms.
We pour walkways and sidewalks that connect driveways, entryways, and backyard spaces, including curved paths and multi-level layouts suited to sloped or wooded lots near Tar Landing. Our concrete steps meet local code requirements for rise and run, and we finish each one with a textured or broom surface to reduce slip risk. We replace cracked or settled sections on older properties, matching existing widths and finishes. Edges near driveways and entry points get extra reinforcement since these zones see the most traffic.
We pour garage floors designed for vehicle weight and daily foot traffic, along with pads for AC units, generators, sheds, and other equipment common on the larger rural lots around Tar Landing, NC. Each pad is sized to the exact equipment footprint so there is no gap or uneven settling once it is placed. Garage floors get a smooth or lightly textured finish depending on whether epoxy coating comes later. We size moisture barriers into garage slabs given the area's high water table.
Jacksonville Concrete Contractors builds every project in Tar Landing, NC around three factors, meaning site preparation, mix design, and reinforcement placement, because the sandy, low-elevation soil in this area makes each step more important than it would be further inland. We select PSI ratings, aggregate sizes, and water-to-cement ratios based on how the slab will be used. Reinforcement and control joint spacing are planned around expected soil movement and temperature swings. Curing schedules are adjusted for the coastal humidity and rainfall this region sees for much of the year.
We evaluate and grade the soil at every Tar Landing site before pouring, since skipping this step leads to cracking, settling, and drainage problems later. Excavation, base compaction, grading, and gravel base installation happen in that order on every job. Coastal soil around Tar Landing tends to be sandy and less stable than soil further from the New River, so we add extra compaction work on these sites. We adjust our approach based on what we find at each specific property rather than using one standard process everywhere.
Concrete mix design determines strength and durability, so we lower the water-to-cement ratio for higher strength, adjust aggregate size for workability and finish, and set PSI rating to match load-bearing needs. Curing time is planned around each mix to support long-term durability. We reinforce every slab with steel rebar or wire mesh sized to the application, and we cut control joints every 8 to 12 feet on standard residential installations. Larger commercial slabs get wider spacing and heavier reinforcement based on structural load and environmental exposure.
Every project moves through the same stages, meaning assessment, preparation, placement, and curing, starting with an on-site visit to check drainage, soil condition, and access before we provide a written scope of work. Grading establishes a 1 to 2 percent fall away from structures, followed by form installation and base preparation with 4 to 6 inches of compacted gravel. We pour, screed, and float the surface before applying broom, stamped, or trowel finishing depending on the project. Concrete supports light foot traffic after 24 to 48 hours, reaches roughly 70 percent strength after 7 days, and reaches full design strength after 28 days.
Standing water is one of the biggest threats to concrete durability near Tar Landing, so we grade every slab with at least a 1/8 inch per foot slope and add French drains or channel drains where needed. We avoid pouring during peak summer heat since high temperatures dry the surface too quickly, favoring early morning pours and wet curing methods instead. Heavy humidity extends our finishing time and pushes us toward moisture-resistant mixes. We monitor short-term forecasts closely and reschedule pours around storm activity given how much rain this coastal region receives.
Tar Landing, NC is a populated place within Jacksonville Township in Onslow County, sitting in the Eastern Time Zone alongside the rest of the county. The area shares a humid subtropical climate with the greater Jacksonville and Camp Lejeune region, with long, hot, humid summers and short, mild winters where snow rarely falls. Areas along Tar Landing Road carry a median age around 40 and a population density near 130 people per square mile, figures that reflect the more spread-out, rural character of properties compared to denser parts of Jacksonville. Roughly 48 percent of residents in the immediate area hold a college degree, with an estimated median household income near $74,297.

Onslow County sees more annual rainfall than the national average for U.S. cities, and afternoon thunderstorms are common through the summer months. Hurricane season runs from June through November and is a significant factor in how concrete work gets scheduled and built in this region. Winters stay short and mild with occasional frost, but snow accumulation is rare. High humidity and heavy seasonal rain both shape how we grade, cure, and seal concrete throughout the year.
Tar Landing sits within a part of Onslow County shaped heavily by its proximity to Camp Lejeune and Jacksonville, established in 1941 and now one of the largest employers and population drivers in the county. Jacksonville itself is one of the youngest cities in the country due to its large military population, while the more rural stretches near Tar Landing and Holly Ridge attract families seeking larger lots and a quieter setting. This mix of long-term residents and military families creates steady, ongoing demand for driveway, patio, and foundation work. New construction and additions remain common as families move into the area.
Onslow County's economy centers heavily on Camp Lejeune and Marine Corps Air Station New River, alongside retail, services, and residential construction tied to that military population. Steady population turnover from military relocations keeps new-home construction and driveway installation in consistent demand throughout Jacksonville Township. Older, established properties near Tar Landing also generate ongoing repair and replacement work as original concrete ages past 20 to 25 years. This combination of new construction and aging infrastructure keeps concrete contractors busy across both ends of the market.
Jacksonville Concrete Contractors has built a reputation across Tar Landing, NC and the wider Onslow County area for durable results and clear communication from estimate to final finish. We hold the required state licensing and carry general liability and workers' compensation insurance, and we provide proof of both without hesitation. Every mix design, reinforcement schedule, and finish we use is selected for the sandy soil, high water table, and coastal humidity found in this specific region rather than applied as a generic template. We also provide references and, when possible, addresses of completed jobs so property owners can see finished work in person.
We have completed residential and commercial concrete projects throughout Onslow County, including driveway replacements, patio installations, and structural slab work suited to conditions specific to Tar Landing and the surrounding communities. Our crews understand how sandy, low-elevation soil near the New River behaves differently than soil further inland. Past clients can speak to the same standards of durability and communication on every job, regardless of size. We stand behind every estimate with a written scope that leaves no room for confusion.
We select PSI ratings, reinforcement, and sealants suited to Tar Landing's coastal exposure rather than a one-size-fits-all mix. Our licensing and insurance cover both residential and commercial concrete work across Onslow County, and we carry the bonding and coverage property owners should confirm before hiring any contractor. Warranty terms are outlined clearly in every written estimate. This combination of proper materials, verified credentials, and documented coverage protects property owners from the risks that come with unlicensed or underinsured concrete work.
Built for Tar Landing's ground, weather, and traffic, poured to last by Jacksonville Concrete Contractors.